37
37
To Rotate or Replace the Bottom Blade:
1. Raise the blade to the up position.
2. Shut down and lockout power to the machine.
3. Unbolt and remove the 2 ball transfer tables and the squaring arm. This will allow access
to the rest of the bottom blade bolts. (fig. 27)
4.
CAUTION:
ALWAYS WEAR LEATHER GLOVES WHEN HANDLING THE BLADE.
Remove the capscrews and washers from the front of the machine that hold the blade in
place while the blade is removed from the back.
5. Turn the blade if you have not already used all four cutting edges, or replace the blade
with a new one.
6. When in position, secure the blade with the bolts and washers.
7. Mount the 2 ball transfer tables and the squaring arm.
8. Set the blade gap arm to the 0.1875
” (4.76mm) setting, start the machine, and lower the
top blade until it overlaps the bottom blade along the full length. The gap should measure
0.023” (0.60mm) along the full length. (The blades must be parallel.)
9. There is no adjustment for the lower blade.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
Keep hands and fingers clear of the shearing blade and clamping cylinders.
figure 27
Squaring Arm
Transfer
Table
Summary of Contents for SH-8008HD
