Baileigh SH-8008HD, Operator'S Manual

Page: 33 / 60

30
30
Inch Mode
When in the
INCH mode the upper blade can be stepped
down gradually. When it reaches the bottom of the stroke it
will automatically raise up. The Inch mode is useful for making
blade adjustment such as blade gap.
1. Place the 3-position selector switch (
E ) in the INCH
position.
2. Clear the shear table.
3. Turn on the main power to start the machine.
4. Re-set the emergency stop button, and start the hydraulic
pump.
5. The upper blade will automatically rise to the upper limit.
6. Set the CUT LENGTH timer ( F ). In the Inch mode it may
be beneficial to set the timer to a slower setting to allow
the blade to be stopped at the desired position more
easily.
7. Load and position the material to be cut.
8. Check that the cutting area has only the material to be cut
and step down on the footswitch. The upper blade will
lower to cut the material as long as the foot pedal is
depressed. When the pedal is released during the down
cycle the blade will stop at that position. When the blade
has reached the lower cut limit it will automatically return
the upper limit position and stop. The blade will remain at
the upper limit position until the foot pedal is pressed
again.
9. The COUNTER will accumulate the number of strokes
automatically.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
Keep hands and fingers clear of the shearing blade and clamping cylinders.
When handling large heavy sheets make sure they are properly supported.
0
0.5
1.0
1.5
2.0
2.5
3.0
X1
X10
S
M
UP PW
TIMER
STPY-M3
SIN
INCH
AUTO
OFF
LAMP
ON
OFF ON
MILD STEEL T.S 64000psi
20GA 10 GA 3/16"
28GA 10GA
STAINLESS T.S 100000psi
14 GA
HAUPTSCHALTER MAIN SWITCH
OFFNEN IN
0-STELLUNG
OPEN IN
OFF - POSITION
O
F
E