29
29
Auto Mode
When performing a cut in
AUTO
mode, pressing and holding
the foot pedal will cycle the upper blade continuously as long
as the foot pedal is depressed.
1. Place the 3-position selector switch (
E
) in the
AUTO
(automatic) position.
2. Clear the shear table.
3. Turn on the main power to start the machine.
4. Re-set the emergency stop button, and start the hydraulic
pump.
5. The upper blade will automatically rise to the upper limit.
6. Set the CUT LENGTH timer (
F
).
7. Load and position the material to be cut.
8. Check that the cutting area has only the material to be cut
and step down and hold the footswitch. The upper blade
will lower to cut the material and automatically return the
upper limit position and repeat the cycle until the foot
pedal is released. The blade will return to the upper limit
position and stop until the foot pedal is pressed again.
9. The COUNTER will accumulate the number of strokes
automatically.
NOTE:
The interval between each cutting cycle
can be set from 1 to 3 seconds with the timer in
the electrical enclosure.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
Keep hands and fingers clear of the shearing blade and clamping cylinders.
When handling large heavy sheets make sure they are properly supported.
0
0.5
1.0
1.5
2.0
2.5
3.0
X1
X10
S
M
UP
PW
TIMER
STPY-M3
SIN
INCH
AUTO
OFF
LAMP
ON
OFF
ON
MILD STEEL T.S 64000psi
20GA
10 GA
3/16"
28GA
10GA
STAINLESS T.S 100000psi
14 GA
HAUPTSCHALTER MAIN SWITCH
OFFNEN IN
0-STELLUNG
OPEN IN
OFF - POSITION
O
F
E
Summary of Contents for SH-8008HD
