Baileigh JP-1250, Operator'S Manual

Page: 34 / 64

31
31
JOINTER OPERATION
Before making any cuts on the stock, make a fe
w practice cuts by raising the infeed table to “0"
and with the power disconnected. This will help you become acquainted with the feel of jointer
operations.
Important: If you are inexperienced at jointing, use scrap pieces of lumber to
check settings and get the feel of operations before attempting regular work.
Check the following before operating the jointer:

Outfeed table must be set level with the high point of the knives.

Stabilize long workpieces by using an assistant, or roller stands set level with the outfeed or
infeed table surface.

The fence should be adjusted to create minimum exposure to the cutterhead during the
jointing operation, and locked at desired angle.

The cutterhead bridge guard/guide must be in place and operating properly.

Infeed table set for desired depth of cut.

Stand away from the cutterhead and turn the machine on for a few moments. Listen for any
odd noises, rubbings, vibrations, etc. Correct such problems before attempting operations on
the jointer.

Carefully check your workpiece for knots, holes, staples or any foreign material that might
damage knives or pose a risk of kickback. Also check the workpiece for grain orientation.
WARNING:

Read, Understand and Follow all safety instructions listed in this manual.

Always wear proper safety equipment such as safety glasses and face shield.

Keep hands, fingers and all body parts away from the cutting blades and all
rotating parts.

Use push blocks to feed material across the cutting blades Never allow your
hands closer than 3” (76.2mm) to the cutting blades.

Never operate the jointer without the cutter head guard in place and functioning
perfectly.
FAILURE TO FOLLOW ALL SAFETY INSTRUCTION MAY CAUSESEVERE INJURY.