Baileigh JP-1250, Operator'S Manual

Page: 25 / 64

22
22
Control Panel Functions
A
– E-Stop Button:
In the event of incorrect
operation or dangerous conditions, the machine
can be stopped immediately by pressing the
E-
Stop Button . Twist the button to unlock and reset
the emergency stop button. Resetting the E-Stop
will not start the machine.
B
– ON Push Button:
Press this button to start the
main motor to power the cutter head.
C
– OFF Push Button:
Press this button to stop
the main motor when finished with a machining
operation.
Bridge Guard/Guide
The bridge guard covers the cutterblock when
surface planing or jointing.
D
– Bridge Guard Rotation Lever:
Lift the lever to allow the complete bridge guard assembly
to rotate off of the table.
E
– Height Adjustment Knob:
Used to increase or decrease the tension on the bride guard.
This changes the clearance to the table for different material thickness when surface planing.
F
– Bridge Guard Arm:
Reaches from the mounting point to the cutter head.
G
– Guard/Guide:
Covers the cutter head to prevent accidental contact. Also used to assist in
guiding the material through the cutter head.
H
– Clamping Screw:
Holds the guard/guide in position.
Note : Instructions to adjust the bridge guard are given in the respective working
techniques descriptions.
Anti-Kickback Guards
1
– Anti-Kickback Fingers
The anti-kickback fingers
prevent the workpiece from kicking back.
Note : Only properly adjusted (smoothly
operating and sharp) kickback fingers will perform this
function properly!
E
D
A
C
B
H
G
F