Baileigh JP-1250, Operator'S Manual

Page: 13 / 64

10
10
SAFETY PRECAUTIONS (cont.)
Blade Height. Adjust the blade to the correct height 41.
above the piece part so it does not kickback toward
the operator causing injury.
Supporting Piece Part. Provide adequate support to 42.
the sides and rear of the table for material that is
extra wide and long.
Push Blocks. Push blocks or push sticks 43.
should be used in situations where it is
necessary to push the piece part against the
fence. Such as when machining narrow
stock, where there is a risk of your hands
and fingers contacting the rotating blade,
resulting in
serious personal injury , or
when surface planing. DO NOT pass your
hands directly over the cutterhead without
using a push block.
EMERGENCY STOP
This machine has an emergency stop (E-Stop) button located on the front left edge of the
machine.
In the event of incorrect operation or dangerous conditions, the machine can be stopped
immediately by pressing the
E-Stop Button . Twist the button to unlock and reset the
emergency stop button. Resetting the e-stop will not start the machine.
UNPACKING
This jointer/planer is shipped complete in one crate. Inspect the entire crate for the components
to be installed onto and complete the machine. Remove the machine from the shipping crate.
Check for damage and ensure all parts are intact. Any damage should be reported immediately
to your distributor and shipping agent. Before assembling, read the manual thoroughly,
familiarizing yourself with correct assembly and maintenance procedures and proper safety
precautions.