Baileigh JP-1250, Operator'S Manual

Page: 17 / 64

14
14
should also be a level surface. If the unit wobbles or rocks once in place, be sure to eliminate
by using shims.

WORKING CLEARANCES: Take into consideration the size of the material to be processed.
Make sure that you allow enough space for you to operate the machine freely.

OUTLET PLACEMENT: Outlets should be located
close enough to the machine so that the power cord
or extension cord is not in an area where it would
cause a tripping hazard. Be sure to observe all
electrical codes if installing new circuits and/or
outlets.

If necessary, the machine can be bolted down to the
floor with the transport brackets.

Remove the oxidation protective layer from all blank
machine parts.
1) Transport brackets
Cleaning
Your machine may be shipped with a rustproof waxy oil coating and grease on the exposed
unpainted metal surfaces. To remove this protective coating, use a degreaser or solvent
cleaner. For a more thorough cleaning, some parts will occasionally have to be removed.
DO
NOT USE acetone or brake cleaner as they may damage painted surfaces.
Follow manufacturer’s label instructions when using any type of cleaning product. After cleaning,
wipe unpainted metal surfaces with a light coating of quality oil or grease for protection.
WARNING:
DO NOT USE gasoline or other petroleum products to clean
the machine. They have low flash points and can explode or cause fire.
CAUTION:
When using cleaning solvents work in a well-ventilated area.
Many cleaning solvents are toxic if inhaled.
GAS