Baileigh JP-1250, Operator'S Manual

Page: 33 / 64

30
30
Changeover from a Planer to a Jointer
Disconnect and lockout power to the machine! 1.
Place the feed roller lever in the lower, disengaged position. 2.
Set the planer table thickness to at least 3” (76.2mm) below the cutter head.
3.
IMPORTANT
: The planer table needs to be at least 3” (76.2mm) below the cutter
head to allow the dust hood to swing past the table to the jointer operating position.
Disconnect the dust collection hose from the planer 4.
hood (A) and connect to the jointer hood (B).
Route the dust collection hose as needed and 5.
verify that the dust hose does not block the jointer
table or interfere with the operator’s movement.
Release the planer hood latch (C) and rotate the 6.
hood counterclockwise downward to rest on the
planer table.
Unlock the table lock (D) or (F) and tilt the jointer 7.
table downward to the flat position.
Repeat for the other table. 8.
Lift the lock lever (C) or (E) and slide inward 9.
toward the center of the table to engage the lock.
Then push down on the lock lever to tighten into
position.
Repeat for the other lock lever. 10.
Adjust the fence and bridge 11.
guard/guide as needed for the jointer
operation to be performed.
Verify that the dust hose does not 12.
block the jointer table or interfere with
the operator’s movement.
D
C
A
F
B
E
C