Baileigh DP-1250VS-HS, Operator'S Manual

Page: 29 / 52

26
Return Spring
The return spring does the raising of the spindle. It has been preset
at the factory and no further adjustments should be attempted. If an
adjustment becomes necessary, please contact a service
representative at Baileigh Industrial. Ph: (920-684-4990)
The figure at right shows the spring cap (A) which houses the spring
and grip knob (B).
Replacing Gearbox Oil
•
1st Time: After initial operation of 30 hours.
•
2nd Time: After 1 month of operation
•
3rd Time: Every 12 months of operation
1. To change the oil you need to remove the cover
plate on the underside of the head.
2. Remove the oil drain plug (AI) visible through the
access hole. (Have a drain pan or container handy to collect
the used oil). Be sure the gearbox is completely empty before
putting the oil drain plug back in.
3. Remove the oil add cover plate (AJ) covering the oil fill tube
and fill the gearbox with fresh SAE 80W-90 gear oil until it
reaches the center of the oil sight window (T).
Oil Disposal
Used oil products must be disposed of in a proper manner following your local regulations.
A
B
T
AJ
AI