Baileigh DP-1250VS-HS, Operator'S Manual

Page: 25 / 52

22
OPERATION
Drilling
1. Load and secure the piece part to the table.
2. Secure drill bit in the chuck.
3. Unlock the table, adjust to the desired height, and relock the table.
4. Adjust the safety guard up or down as needed.
5. Select the transmission mode with handle (B)
Important: DO NOT change transmission spindle
selection until the spindle has stopped completely. Switching
transmission with the motor on and spindle turn can damage gears.
6. Select drilling mode with selector switch (AE). Selector switch (AE)
shown in drill position.
7. Set the drill bit depth to zero position by lowering it to the top surface of the
piece part, using the down-feed handles.
8. While holding the zero position, turn the depth scale lock knob (AL)
counterclockwise (ccw) to release depth stop knob (P).
9. Rotate Knob (P) to set the drill depth on the scale with indicator (R).
10. Re-tighten lock knob (AL).
11. Start machine by pressing start button (AE).
12. Turn on the coolant selector switch (AA).
13. Begin drilling using the down-feed handles to lower the chuck.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges. When handling
large heavy materials make sure they are properly supported.
DIGITAL INDICATOR
RPM
0
l
245-2000
65-540
0 l
0
AG
AE
P
AL
R