Baileigh DP-1250VS-HS, Operator'S Manual

Page: 27 / 52

24
Removing Tooling From Spindle
1. Disconnect machine from the power source.
2. Place a piece of wood on the table for protection.
3. Position the work table approximately 10” under the bit and
lower the spindle about 6”.
4. Place the drift key (AM) into the slot (AN) of the quill and tap the
end of the drift key with a hammer until the bit or chuck arbor
falls out.
MATERIAL SELECTION
When selecting materials keep these instructions in mind:
•
Material must be clean and dry. (without oil)
•
Material should have a smooth surface so it processes easily.
•
Dimensional properties of material must be consistent and not exceed the machine capacity
values.
•
Chemical structure of material must be consistent.
•
Buy certificated steel from the same vendor when possible.
CAUTION:
It must be determined by the customer that materials being
processed through the machine are NOT potentially hazardous to operator or
personnel working nearby.
AM
AN