Bahco TASMB Series, Original Instructions Manual

Page: 32 / 884

TASMB AND TAWMB SERIES
SLIM
1RWH0HQXVHOHFWLRQLQGLFDWHVFXUUHQWFRQ¿JXUDWLRQ(1$%/('RU',6$%/('
TORQUE AND ANGLE MODE
7RUTXH$1'$QJOHPRGHLVVHWXSE\¿UVWVHWWLQJDWDUJHWWRUTXHDQGXQLWVWKHQDWDUJHWDQJOHEHIRUHVH
-
lecting Torque AND Angle mode. In Torque AND Angle mode, torque and angle are measured simultane-
ously. Yellow progress lights track torque measurement. When both torque and angle reach their targets,
green progress lights turn on and torque and angle data record is stored. If either of measurements
exceed their upper tolerance, red progress lights turn on.
1. From target torque screen, use UP/DOWN buttons to set target torque and UNITS button to select
torque measurement units then press ENTER button.
2. Angle target screen is displayed. Use UP/DOWN buttons to set target angle then press ENTER
button until Torque AND Angle mode screen is displayed.
3. Apply torque and rotate wrench until both targets are reached.
STD
SLIM
Note: UNITS button can be used to select torque units while on Torque AND Angle screen.
Note: Torque THEN Angle Presets are entered by pressing and holding Units button while on
(1$QJOHVFUHHQ5HIHUWR³$GGLQJD7RUTXH3UHVHW´DQG³$GGLQJDQ$QJOH3UHVHW´
in Basic section for parameter entry.