Bahco TASMB Series, Original Instructions Manual

Page: 42 / 884

TASMB AND TAWMB SERIES
• 6 MON
• 3 MON
•
DISABLED
3UHVV(17(5EXWWRQWRDFFHSWVHOHFWLRQDQGH[LWWR&RQ¿JXUHPHQX
STD SLIM
Note: Clock Date and Time must be set before calibration interval will function. If batteries are
removed from wrench for longer than 20 minutes, clock will revert to default settings and must
be re-entered at power on.
Note: Calibration interval is calculated from either IN-Service Date or last Calibration date
VHH6+2:,1)2PHQXLQ2SHUDWLRQ0DQXDOGHSHQGLQJRQZKLFKLVPRUHUHFHQWGDWH:KHQ
FORFN'DWHLVJUHDWHUWKDQ,16HUYLFHRU/DVW&DOLEUDWLRQGDWHSOXV&DO,QWHUYDO³&$/1(('('´
message will be displayed.
Note: If wrench is not locked (see Set Calibration Needed Countdown section below), pressing
ENTER button will continue to target menu or applying torque will immediately display torque
or angle measurement and return to target menu when released.
1RWH ,I DQ LQYDOLG GDWH LV HQWHUHG DQG &DOLEUDWLRQ LQWHUYDO LV HQDEOHG DQ XQLQWHQGHG ³&$/
NEEDED” message may be displayed. Either disable calibration interval or enter a correct date.
SETTING CALIBRATION NEEDED COUNTDOWN
This function will allow user to set number of days when “CAL NEEDED” message will be displayed
along with days remaining before a wrench lock out occurs due to calibration interval expiring.
1. From Calibration menu, use UP/DOWN buttons to highlight CAL COUNTDOWN selection then press
ENTER button.
2. CAL COUNTDOWN screen is displayed.
3. Use UP/DOWN buttons to change calibration countdown.
Range: 0 to 10 days.
3UHVV(17(5EXWWRQWRDFFHSWVHOHFWLRQDQGH[LWWR&RQ¿JXUHPHQX