43
44
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
3. Adjust the harness strap height for your
child – Harness straps MUST be at or
above the child’s shoulders (see
“Changing Harness Strap Height”
Section 10.3
).
4. Route the LATCH lower anchor belt using
the “
REAR ENTRY
” belt routing as shown
in Section 7.2.
5. Place the car seat on the vehicle seat in
a seating location equipped with LATCH
and centered between the LATCH
anchorages (see “Selecting a Vehicle
Seating Location” section).
6. If the vehicle seat back is adjustable, adjust
into the upright position or the position
specified in the vehicle owner’s manual
for use with a car seat.
7. Use the LATCH connectors to hook into the
vehicle anchors as seen in
(1)
and
(2)
.
Ensure the connectors hook securely
into the vehicle anchorage.
8. Pull to check that the
connectors are securely
attached
(3)
.
REAR
ENTRY
Belt
Routing
9. Place your knee inside seat
(1)
and pull on the free end of the LATCH
strap to tighten
(2)
(Fig 44a).
10. Check for a secure installation by grasping
the car seat armrest and pushing side-to
-side and front-to-back. The car seat
should not move more than 1 inch in
either direction (Fig. 44b).
• If the car seat moves more than
1 inch, retighten the LATCH belt
and check again.
• If the car seat moves less than 1 inch,
installation is complete. However if
the car seat still moves more than
1 inch, try another seating position
or see the “Vehicle Seat Belts”
section and check your vehicle owner’s
manual for information on securing
car seats.
1
2
3
LATCH
Connector
Fig. 44b
Fig. 44a
2
1
Summary of Contents for HYBRID
Page 50: ...97 98 NOTES...