BABYTREND HYBRID, Owner'S Manual

Page: 21 / 50

39 40
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
2
1
4
3
1
2
4
3
7. Pull the vehicle Lap belt out and route
through the car seat using the “ FRONT
ENTRY ” belt routing as shown in Section
7.2 and buckle the vehicle seat belt.
8. Pull to check that the vehicle buckle
is securely locked.
NOTE: If Lap belt is not long enough
and LATCH system is not available,
install Car Seat using “ REAR ENTRY ”
belt path, (see “Installation - Lap Belt
Only WITHOUT Top Tether” section).
9. Place knee inside seat and while pressing
down (1) , pull on the free end of the vehicle
lap belt (2) to tighten the lap belt around
the car seat.
10. Attach top tether hook to vehicle tether
anchor as shown in (1) and (2) .
Ensure the top tether hook is clipped
on and secured to the vehicle anchor.
11. Pull on the Top Tether Strap to check
that the Tether Hook is securely
attached (3) .
12. Pull on free end of Top Tether Strap
until all slack is removed from
the Top Tether (4) .
Top
Tether
FRONT
ENTRY
Belt
Routing
2
1
Tether
Adjuster
13. Check for a secure installation by grasping
the car seat armrest and pushing side-to
-side and front-to-back. The car seat
should not move more than 1 inch in
either direction.
• If the car seat moves more than 1
inch, retighten the vehicle seat belt
and Top Tether and test again.
• If the car seat moves less than 1 inch,
installation is complete. However if the
car seat still moves more than 1 inch,
try another seating position or see the
“Vehicle Seat Belts” section and check your vehicle
owner’s manual for information on securing car seats.
To remove car seat:
1. Loosen Top Tether by pressing the button
on Tether Adjuster and sliding belt through
adjuster (1) .
2. Unhook Top Tether Hook for vehicle tether
anchor. Press up on retainer (2) , unhook
Tether Hook (3) , and remove (4) .
3. Unbuckle vehicle seat belt and remove
seat belt from belt path.