49
50
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
To secure car seat in vehicle:
1. Assemble of the Back Support (see
“Assembly and Removal of Back
Support”
Section 10.1
).
2. Store LATCH and Top Tether by
securing LATCH Connectors and
Tether Hook on LATCH/Tether Storage
Bar at bottom of Back Support as shown.
3. Adjust the harness strap height for your
child – Harness straps MUST be at or
above the child’s shoulders (see
“Changing Harness Strap Height”
Section 10.3
).
7.4.3 Installation - Lap Belt Only
WITHOUT
Top
Tether
Vehicle seat belt system
Vehicle seat belt system MUST
MUST stay tightly adjusted to
stay tightly adjusted to
car seat at all times. If vehicle seat belt does not stay
car seat at all times. If vehicle seat belt does not stay
tight, read vehicle owner’s manual and “Vehicle Seat
tight, read vehicle owner’s manual and “Vehicle Seat
Belts’ section in this manual.
Belts’ section in this manual.
4. Place the car seat on the vehicle seat in
a seating location and centered between
the Lap belt anchorages (see “Selecting
a Vehicle Seating Location” section).
5. If the vehicle seat back is adjustable, adjust
into the upright position or the position
specified in the vehicle owner’s manual
for use with a car seat.
6. Pull the vehicle lap belt out and route
through the car seat using the “
REAR
ENTRY
” belt routing as shown in
Section 7.2 and buckle the vehicle
seat belt.
7. Pull to check that the vehicle buckle is
securely locked.
8. Place knee inside seat and while pressing
down
(1)
, pull on the vehicle lap belt to
tighten the lap belt around the Car Seat
(2)
.
1
REAR
ENTRY
Belt
Routing
LATCH Connectors
Top Tether
Tether/LATCH
Storage
2
WARNING
WARNING
Summary of Contents for HYBRID
Page 50: ...97 98 NOTES...
