BABYTREND HYBRID, Owner'S Manual

Page: 24 / 50

45 46
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
1
2
3
To secure car seat in vehicle:
1. Assemble the Back Support (see
“Assembly and Removal of Back
Support” Section 10.1 ).
2. Store LATCH and Top Tether by
securing LATCH Connectors and
Tether Hook on LATCH/Tether
Storage at bottom of Back
Support as shown.
3. Adjust the harness strap height for your
child – Harness straps MUST be at or
above the child’s shoulders (see
“Changing Harness Strap Height”
Section 10.3 ).
To remove car seat:
1. Loosen LATCH lower anchor belt by
putting knee in seat and while pressing
down (1) , lift up on LATCH Adjuster and
slide belt through adjuster (2) .
2. Unhook LATCH lower anchor belt
connectors from vehicle anchors.
Press up on retainer (1) , unhook
LATCH Connector (2) , and remove (3) .
NOTE: When removing the LATCH
connector, rotating the connector
90º can assist in removal from
vehicle anchor.
1
2
7.4.2 Installation - Lap/Shoulder Belt WITHOUT Top
Tether
Vehicle seat belt system Vehicle seat belt system MUST MUST stay tightly adjusted to stay tightly adjusted to
car seat at all times. If vehicle seat belt does not stay car seat at all times. If vehicle seat belt does not stay
tight, read vehicle owner’s manual and “Vehicle Seat tight, read vehicle owner’s manual and “Vehicle Seat
Belts’ section in this manual. Belts’ section in this manual.
LATCH Connectors
Top Tether
Tether/LATCH
Storage
WARNING WARNING