BabyLove Baby Capsule, Manual

Page: 18 / 35

34 35
Setup - Setting Up The Harness Setup - Setting Up The Harness
Press
C
Press
B
A
Pull
1.
2. 3.
A. Press harness adjuster
button (located under
trim.)
B. Place your hand under
both shoulder harness
straps, then pull shoulder
harness straps to
lengthen.
C. Disengage the buckle by
pressing the red button.
If your child is less than 3kg then
you will probably need to use the
harness arrangement for smaller
babies.
When positioning baby into
capsule make sure baby's back
is fully supported onto the flat
section and the baby's nappy
area (bottom) is resting in the
bottom curvature as shown.
It is recommended that bulky
nappies are not used when baby
is traveling in the Baby Capsule
as they can cause incorrect
positioning of the baby's back in
the Baby Capsule.
Flat
back
rest
Curved seat
Positioning Baby Into Capsule
The Capsule is fitted with four shoulder strap positions. Always
adjust the height of the shoulder straps as the child grows.
It is better to change one strap at a time so that the other strap
will be a guide for re-assembly.
The shoulder straps must be in the slots which are nearest to the
child’s shoulders, but not lower than the child’s shoulders.
Remove straps from yoke
At the rear of the Capsule,
remove one of the harness
shoulder straps from yoke by
slipping strap through slot.
Pull the shoulder strap
through cover slot into to
the seating area of the
capsule.
Pull through cover
Harness Straps Not Below Green Zone
Low Birth
Weight
Average
Newborn
Growing
Infant
Larger
Infant
Adjusting The Shoulder Straps As Child Grows