20
21
Child Seat Features - Rearward Facing
Front of
vehicle
22.
Vehicle’s
Anchor
Fitting
26.
Long or short
Vehicle Seat
Protector
(If supplied)
21.
Attachment
Clip
28.
Top Tether
Storage Pocket
29.
Top Tether
Adjuster
23.
Top Tether
Adjuster
Strap
27.
Top
Tether
Setup - General Information
Child seat upper anchorage point
This child seat must be installed using the top tether. The top
tether will need to attach to the appropriate upper anchorage
point for rearward facing mode. Refer to the car owner’s
handbook for anchorage locations or points. If your vehicle does
not have an upper anchorage point then you will need to install
an upper anchorage point. Refer to pages 58 to 63.
Is there enough room?
THE TETHER STRAP MUST ALWAYS BE
FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
Do not use the restraint without the
top tether strap correctly attached.
DO NOT USE A REAR FACING CHILD
RESTRAINT WHERE AN AIRBAG IS FITTED
IN FRONT OF THE SEATING POSITION.
Do not use on any vehicle seat
which faces sideways or rearwards.
The Baby Capsule may just touch the front seat, but must not in
such a way that the installation angle is affected.
Do not allow the front seat to alter the installed angle of the
restraint.
24.
Top Tether Guides
25.
Capsule Release Lever
(from Base or Stroller)
12.
Release
Handle
To ensure that the
space is sufficient, the
purchaser should check the
measurements between the
vehicle’s rear and front seats
in which the child restraint is
intended to be used.
717mm
355
mm
Width 420mm
Summary of Contents for Baby Capsule
Page 34: ...66 67...
