![background image](http://html1.mh-extra.com/html/baby-trend/fb58944/fb58944_owners-manual_3243197023.webp)
7.6
Installation
WITH
Lap Belt only
7.6.1
Installation - Lap Belt only
FRONT ENTRY
Belt Routing
• Use this installation method when using WITH
Top Tether and use with children 40 to 50 lbs.
(18 to 23 kg).
To secure car seat in vehicle:
1. Assemble the Back Support (see “Assembly
and Removal of Back Support” section).
2. Store LATCH connectors on back of seat.
9. Place knee inside seat and while pressing
down , pull on the vehicle shoulder belt just
above the vehicle buckle to tighten the
vehicle lap belt around the Car Seat.
10. While holding the lap belt tight, pull slack
out of shoulder belt and allow retractor
to tighten shoulder belt.
11. Check for a secure installation by grasping
the car seat armrest and pushing side-to-side
and front-to-back. The car seat should not
move more than 1 inch in either direction.
• If the car seat moves more than
1 inch, retighten the LATCH belt
and test again.
• If the car seat moves less than 1 inch,
installation is complete. However if the
car seat still moves more than 1 inch,
try another seating position or see the
“Vehicle Seat Belts” section and check
your vehicle owner’s manual for
information on securing car seats.
Use of a Belt Locking Clip may
be required.
To remove car seat:
1. Unbuckle vehicle seat belt and remove seat
belt from belt path.
43
7.0
Toddler Car Seat (
With
Built-in
Harness) Installation and Use
7.0
Toddler Car Seat (
With
Built-in
Harness) Installation and Use
44
WARNING!
• Vehicle seat belt system MUST stay tightly adjusted to car
seat at all times. If vehicle seat belt does not stay tight, read
vehicle owner’s manual and “Vehicle Seat Belts” section in
this manual.
• Harness straps MUST be routed between back of the Back
Support and the vehicle lap belt when installed using “FRONT
ENTRY” belt routing.
• Top Tether MUST be used for this installation.
1
1
2
2
LATCH Connectors