DOREL
-COMMUTER
-VENTURA
-HIGH BACK BOOSTER
(Front-adjust harness models only)
Type:
Combination child seat/booster
Last date made:
Current
First made:
1999; with LATCH 2002
Weight limits:
22*-40 lbs. with harness, 40-80 lbs. as belt-
positioning booster with vehicle lap-shoulder belt on child.
*Previous minimum weight limit was 20 lbs.
Harness:
5 point harness (removable)
Page 1 of 2
Harness:
Harness strap ends are sewn in loops and
attached to a splitter plate behind seat (diagram 1). The
lap straps are threaded through slots at hips and run
straight across under seat. To tighten the harness, pull
the strap end at lower front of seat. To loosen, lift or push lever (depending
on model) while pulling on shoulder straps.
Harness slots:
There are two sets of slots. Since the seat can only be used
facing forward, all slots are permitted. To change strap slot height, remove
straps from splitter plate, thread through desired slots and re-attach to splitter
plate.
Crotch strap:
The crotch strap is sewn to a metal slide which must lie flat
against plastic shell under child. It is non-adjustable.
Angle adjustment:
None
Belt path:
With harness:
The vehicle belt is routed through the sides of the
seat behind the child (diagram 2).
Without
harness:
Remove the harness from the seat, and secure
the LATCH and tether hooks behind the seat shell to prevent them from
striking anyone. Use the vehicle lap-shoulder belt on child (diagram 3). Do
not use the belt guide on the side of the seat to position the shoulder belt
unless absolutely necessary for correct fit on child. Caution parent to
watch that child doesn’t pull belt forward while in use, as it may not retract
into position easily when the belt guide is used.
SEE PAGE 2
2
3
1
Important: This information sheet is not a substitute for complete manufacturer’s directions and current recall list.
SafetyBeltSafe U.S.A., P.O. Box 553, Altadena CA 91003 (310) 222-6860 (800) 745-SAFE ©SafetyBeltSafe U.S.A. #48 01/07
