Baby Jogger City tour 2, Assembly Instructions Manual

Page: 12 / 28

12
WARNING: When making adjustments
to the stroller seat, make sure child’s
head, arms, and legs are clear of
moving seat parts and stroller frame .
POCKET (on certain models)
23 To access the storage pocket, open
pocket opening on back of the canopy .
WARNING: Do not load storage pocket
if parent console is used .
LEG SUPPORT INCLINE
24 Lift the leg support up in order to raise
it .
25 To lower the leg support, pull the
release bar underneath it and push it
down .
BASKET REMOVAL
26 From under the front of the stroller,
unfasten and unloop the four snaps .
27 Raise the calf support and undo the
fastening strip underneath the leg
support .
28 Pull the seat fabric off of the calf
support bar .
29 Unscrew the two screws on either side
of the calf support bar .
30 Pull the calf support bar up and out of
the grooves .
31 From underneath the stroller, unfasten
the snaps of the basket near the rear
of the stroller .
32 At the rear of the stroller, push up on
the hanging clips to remove them from
the stroller frame .
33 Pull the basket fabric out of the
channels in the footwell .
FOLDING
• Remove your child from the seat .
• Disengage front wheel swivel locks if
engaged .
• Remove all attachments and all items
from basket .
34 Slide the handlebar fold release button
and hold it, then squeese the fold
button on the handle bar and fold the
handlebar forward .
35 Fold the upper stroller frame down to
the lower stroller frame .
36 Pull up on the strap on the seat and let
the frame collapse .
37 Make sure the auto-lock lever clicks
into place .
REMOVING THE SEAT FABRIC
38 From the underside of the seat,
unfasten the hook-and-loop and slide
the strap through the D-ring .
39 Unfasten and unloop the two snaps
underneath the seat .
40 Undo the fastening strip underneath
the leg support .
41 Undo the six fastening strips on
the back of the seat (A). On certain
models you will need to unsnap the
snaps on the back of the seat (B).
42 At the top of the seat, pull the seat
fabric out of the channels in the frame .
NOTE: To reattach seat fabric, reverse
steps 38-42 . Push the seat piping at a
slight angle into the channel until the
seat in fully installed . Do not pull on the
fabric .
WARNING: Make sure that all fasteners
are properly closed when re-attaching
the seat fabric .
EN