B+B SMARTWORK SPECTRE V3, Configuration Manual

Page: 15 / 136

3. STATUS
3.1.2 Primary LAN, Secondary LAN, Tertiary LAN, WiFi
Items displayed in this part have the same meaning as items in the previous part. More-
over, the MAC Address item shows the MAC address of the corresponding router’s interface
( Primary LAN – eth0, Secondary LAN – eth1, Tertiary LAN – eth2, WiFi – wlan0 ). Visible
information depends on configuration (see 4.1 or 4.5 ). If the router is equipped with PoE PSE
board, there is also information about it in the Primary LAN or Secondary LAN section (see
table below for description).
Item Description
PoE PSE Status
• Disabled – PoE PSE is disabled in the Primary LAN or Sec-
ondary LAN
configuration form.
•
Undervoltage
– Undervoltage, i.e. a lower voltage than the
nominal operating voltage.
•
Overcurrent – Overcurrent, i.e. a higher current than the
permissible positive difference of the nominal current.
• Idle – PoE PSE is enabled, but currently not used.
• Class 0 – Power level (classification unimplemented)
• Class 1 – Power level (very low power)
• Class 2 – Power level (low power)
•
Class 3
– Power level (mid power)
•
Class 4
– Power level (high power)
PoE PSE Power Power of PoE PSE [W]
PoE PSE Voltage Voltage of PoE PSE [V]
PoE PSE Current Current of PoE PSE [mA]
Table 2: PoE PSE information
3.1.3 Peripheral Ports
Item Description
Expansion Port 1 Expansion port fitted to the position 1 (
None
indicates that this
position is equipped with no port)
Expansion Port 2 Expansion port fitted to the position 2 ( None indicates that this
position is equipped with no port)
Binary Input State of binary input
Binary Output State of binary output
Table 3: Peripheral Ports
6