22
#F-delay_1
F-Delay
sets the amount of delayed Frames. The available range is
from 0 to 125 frames (dependant on the video format). Default is
0F
.
The preset master for this is
Dly_Frmt_Prst
, hence the ‘#’-prefix.
#V-Delay_1
V-Delay
setting allows adjustment of the vertical phase of the output
signal with respect to the selected reference input. The
V-Delay
setting
gives a delay in addition to the reference timing. For example: if
V-Delay
is set to 10 TV HD lines, the output signal will be delayed by
reference 10 TV HD lines. The signal is delayed (advanced)
with respect to the phase of the reference signal. The available range is
from 0 to a maximum of 1125 lines (dependant on the video format).
The default setting is
0ln
. The preset master for this is
Dly_Frmt_Prst
, hence the ‘#’-prefix.
#H-Delay_1
The
H-Delay
setting allows adjustment of the Horizontal phase of the
output signal with respect to the selected reference input. The
H-Delay
setting gives a delay in addition to the reference timing. For example: if
H-Delay
is set to 10 pixels, the output signal will be delayed by
reference 10 pixels. The signal is delayed (advanced) with
respect to the phase of the reference signal. The available range is from
0 to a maximum of 5124 pixels (dependant on the video format). The
default setting is
0px
. The preset master for this is
Dly_Frmt_prst
,
hence the ‘#’-prefix.
Delay-Status
It is possible to display (in the status menu
IODelayA
and
IODelayB
) the processing time of the card in the status menu. This
setting allows you to switch this function
ON
or
OFF
. Default setting is
OFF
LockMode
Lock-Mode
determines whether the card is locked to
his
input
(input
1), to the reference (
Ref1
or
Ref2
) or
freerun
(not locked). By
default it is set to
Ref1
. Can also be set to
RefAuto
.
Ref1
is default.
When set to
RefAuto
the card chooses ref1 as its source. Whenever
ref1 fails, it will switch to ref 2 (only for SFR08 and SFR18 frames and
only when ref2 offers the same ref format as ref 1). When ref 1 is back
up again, it will only automatically switch back to ref 1 when ref 2 fails.
Ref-Type
Sets the type of incoming reference. Can be either Bi-Level or
Tri-
Level
. Default is
Bi-Level
.
P60-P50_Sync
With this setting you can choose to synchronize each
one frame
or
each
two frames
. Default is
One Frame
. The two-frame-
synchronize mode only works for 720p60, 720p50, 1080p50 and
1080p60 standards.
