18
Timecode_ins
(Only in GIX-HIX 110)
Here you can set if the time code on the inputs should be copied to the
outputs (
on
). You can also turn
off
time code re-insertion. Default is
off
.
S352_Insert
S352_Insert
enables (
on
) the Video Payload Identifier insertion in
the HANC space. Default is
on
. This packet is required for 3G
standards. In HD 1080i for ATC-LTC transparency the user may switch
it off to pass the ATC-LTC HANC packet on line 10.
VITC_Ln-In
VITC_Ln-In
sets which line the time code reader reads the time code
from. This in a range from line 7 to line 20. Default line is 8.
OP47-Error-Det
This item controls the presence detection of OP47 SDP VANC data
packets. Whenever the OP47 is not detected in a frame, it is detected as
an OP47 presence error. Empty OP47 packets are detected OK, and is
thus not an error.
Off
: the functionality is switched
OFF.
Probe
: the card will detect an OP47 error, but will only give this as
a status item. The card will not switch to the other channel.
A
: the card will detect an OP47 error on channel A and switch to the
other channel when an error is detected.
B
: the card will detect an OP47 error on channel B and switch to the
other channel when an error is detected.
A+B
: the card will detect an OP47 error on both channel A and B
and switch to the other channel when an error is detected.
The default setting is
A+B
.
WST-Error-Det
This item controls the presence detection of WST-B data packets in SD.
Whenever the WST is not detected in a frame, it is detected as an WST
presence error. Empty WST packets are detected OK, and is thus not an
error.
Off
: the functionality is switched
OFF.
Probe
: the card will detect a WST-B error, but will only give this
as a status item. The card will not switch to the other channel.
A
: the card will detect a WST-B error on channel A and switch to the
other channel when an error is detected.
B
: the card will detect a WST-B error on channel B and switch to the
other channel when an error is detected.
A+B
: the card will detect a WST-B error on both channel A and B
and switch to the other channel when an error is detected.
The default setting is
A+B
.
