Assembly
16
3). Put to hand six M6 x 16mm Phillip head screws
with square nuts (O3), remove the nuts and place
safely aside. Slot the screws into each of the 6 holes
on the extention table lip (M), replace the square
nuts, see figs 41-42. (Note: Leave a gap between
the base of the extension table lip and nut)
Fig 41-42
O3
M
M6x16mm Phillips screw
4). Remove the plastic covers from the ends of the
two extension table support arms (N), see fig 43.
Offer up the M6 nuts to the support arms T-slots
and slide on the extension table (M) into the support
arms (N). Push the extension table (M) until it is flush
up against the saw table (A), place six Phillips screws
(O1) into the captive nut locations, place a level
between both tables, adjust the screws (O1) until
both tables are level. Tighten the six M6 Phillips
screws (O3) to clamp the extension table to the
supporting arms (N). Replace the plastic covers you
removed earlier, see figs 44-45-46-47.
Fig 44
Fig 45
Fig 43
Fig 46
Fig 47
‘T’ Slot
Captive nut
M
O1
O1
Plastic cover
03
Summary of Contents for Hobby series TS-250M
Page 28: ...Parts Breakdown List 28...
Page 30: ...Parts Breakdown List 30...
