Assembly
17
Rip Fence
NOTE: THIS ASSEMBLY
OLNY APPLIES IF YOU HAVE
PURCHASED KIT CODE: 508212
1). Remove the fence clamp assembly from the rip
fence (E) by lossening the clamping bolt to the base
of the asssebly. using a 10mm socket/spanner. Locate
the rip fence (Q), slot the steel square clamp into the
T-slot to the end of the rip fence and tighten the bolt,
see figs 48-49.
Fig 48-49
Steel square clamp
10mm socket/spanner
Clamping bolt
Q
2). Lower the fence assemby so the clamp assembly
slots over the fence extention table support arm (N).
Clamp the fence assembly in position by turning the
lift and shift handle clockwise, see figs 50-51.
Note: Lubricate the Fence supporting arm (N) and
the underside of the clamp assembly so the rip
fence assembly runs smoothly back and forth.
Fig 50-51
Clamp asssembly
Q
Dust Extraction
1). Locate 30mm hoses (B), hose clips (G2), 100mm
dust extraction moulding with four Phillips screws
and washers (C).
2). Place one of the hose clips over one end of the
30mm hose and fit the hose over the table saws dust
extraction outlet and nip tight, see fig 52.
Fig 52
DO NOT OVERTIGHTEN as the guard is only plastic!
Continues Over...
B
G2
Summary of Contents for Hobby series TS-250M
Page 28: ...Parts Breakdown List 28...
Page 30: ...Parts Breakdown List 30...
