Assembly
12
7). Locate the two carriage arm stops (W4), loosen
the domed nuts and slide the bolt heads into each
end of the carriage arms ‘T’ slot. Tighten the nuts to
lock the stop in place, see fig 17.
Fig 17
W4
Angle Fence
1). Put to hand the work clamp block (U), and slide it
into the T-slot on the angle fence (R). Locate the
connecting block (U) and slide it onto the angle fence
as before, see figs 18-19. Slide the T-bolt on the base
of the connecting block (U) into the T-slot on the
sliding carriage table (Y), see figs 20-21. Locate the
plastic block and Phillips screws (R1), secure it to the
end of the angle fence (R), see fig 22.
Fig 18-19
R
U
U
Work clamp block
Connecting block
Fig 20-21
Fig 22
The picture above shows the angle fence (R)
removed from the carriage table for clarity.
Y
‘T’ Slot
‘T’ Bolt
‘T’ Bolt
Connecting block
R1
2). Locate the work clamp (S), slot the work clamp
into the 20mm hole in the work clamp block (U),
secure in position with the lift and shift handle, see
fig 23. To set the angle fence at 90˚, push the angle
fence (R) up against the stop, see fig 24.
3). Make sure the plastic block on the end is just
missing the blade. Using a 90˚ square check that
the blade is at 90˚ to the angle fence (R), see fig 25.
When correct tighten the lift and shift handle on the
Lift and shift handle
Summary of Contents for Hobby series TS-250M
Page 28: ...Parts Breakdown List 28...
Page 30: ...Parts Breakdown List 30...
