Assembly
13
Fig 23
S
U
Lift and shift handle
Fig 24
Angle fence stop
connecting block (U), see fig 21. If the angle fence (R)
is not set to 90˚, undo the grub screw to the side of
the sliding carriage table (Y), using a flat screwdriver
turn the eccentric bush until the angle is correct, see
figs 26-27.
4).To set the angle fence (R) to angles between 45˚
and 90˚ loosen the three lift and shift handles on
the connecting and work clamp blocks (U) and set
the fence to the required angle on the scale on the
Fig 25
Fig 26-27
Grub locking screw
Eccentric bush
carriage table (Y), see figs 28-29. Tighten the three
lift & shift handles to lock the angle fence in position.
Note: The fence can also be used at the rear of the
sliding carriage table if you prefer to push the
timber against the fence.
Fig 28-29
Continues Over...
Carriage table scale
90˚ Square
Summary of Contents for Hobby series TS-250M
Page 28: ...Parts Breakdown List 28...
Page 30: ...Parts Breakdown List 30...
