Assembly
11
Fig 11
Fig 12
NOTE: Only screw on the bolts just enough so they
are just below the surface of the threaded nut, see
fig 11.
4). Line up the Hex bolts (W3) with the ‘T’ slots in the
carriage arm (X) and slide on the carriage arm, see
fig 13.
Fig 13
w
3
w
3
w
1
Threaded nuts
‘T’ Slot
V
X
5). Locate the sliding carriage table (Y) and slide it
onto the carriage arm (X), see fig 14.
Make sure the wheels on carriage table engages
correctly onto the carriage arm rails, see fig 15.
Fig 14-15
Carriage arm rail
Y
6). Slide the carriage table (Y) to one end of the saw
table (A), place a Level across both tables and adjust
the M6 Hex bolts (W1) until the sliding carriage table
(Y) is level with the table saw table (A), see fig 16.
Repeat for the opposite side. When both tables are
level tighten the four M6 Hex nuts (W3) to secure the
sliding arm (X) in position.
Fig 16
Continues Over...
Summary of Contents for Hobby series TS-250M
Page 28: ...Parts Breakdown List 28...
Page 30: ...Parts Breakdown List 30...
