Operation instructions | MIP 8-00 | MIP 16-00 | MIP 8-06 | MIP 16-06
Page 36 of 48
BA_MIP-8-16-0x.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-01-10
5.4.2.
Save Initialization Data
In the section SAVE SYSTEM INITILIZATION DATA TO FILE you can save the current initilization data from phase 1 to 3 into a
file on your computer.
Click on SAVE.
The config.dat file is generated. You can save these on your computer.
Click on PDF TO PRINT.
A PDF of the configuration is generated that can be opened or saved.
Note:
Password and IP adress will not be saved.
5.4.3.
Upload Initialization Data
In the section UPLOAD SYSTEM INITILIZATION DATA FROM FILE you can upload the initiaization data from a file to the device.
Choose a CONFIGURATION FILE.
Click on UPLOAD.
The upload will take a few seconds.
After the upload you have to log in again.
5.5.
Reboot
5.5.1.
Rebooting
Under REBOOT THE SYSTEM the device can be rebooted.
Click on REBOOT.
After rebooting, the password must be entered again.
Note:
If input signals are temporarily unavailable (e.g. due to snow), the device will reboot every 10 minutes. This ensures that
all configured programmes will be available once the input signal becomes available again.
