2: I
np
ut
s a
nd O
ut
pu
ts •
1
4
©2012 Axia Audio
Figure 2-3 shows the setup options screen for a
typical Microphone source. Figure 2-4 shows a Codec
source which has a few different settings, and Figure 2-5
shows a Line source. The following sections describe
these Source configurations in detail.
Source type
This display-only parameter shows you the source
type as selected in the previous step (Line, Codec, etc).
Source name
Each Source needs a name for display on the con-
sole’s OLED channel displays. Names can be up to 10
characters long and may include spaces or underscore
characters.
Source input
This setting associates the source with an audio input.
It may be a
local
input in which case you would choose
a local Mic, Analog or AES from the drop-down menu.
This source may also be a
Livewire
source which means
that it is a network source originating from some other
Livewire device. When you choose Livewire as your
Source Input, you will specify a network source. See
Chapter 7: Livewire Networking
for details.
Primary Source
This pop-up window is used to select the network
Livewire source ONLY when
Livewire
has been se-
lected as your Source Input. See
Chapter 7: Livewire
Networking
for more on this.
Signal Mode (non-Microphone Sources)
Determines whether source will be treated as a mono or
stereo source.
•
Stereo
feeds incoming L/R signal to left and right
channels of assigned bus(es).
•
Left
feeds incoming left channel to both channels of
assigned bus(es).
•
Right
feeds incoming right channel to both channels
of assigned bus(es).
•
Sum
creates L+R mono mix of incoming stereo
source and feeds it to both channels of assigned
bus(es).
Signal Phase (non-Microphone Sources)
Determines whether source will maintain normal or
inverted phase relation.
Fader trim gain
This setting allows you to specify an amount of gain
from -25 to +25 dB. Fader Trim Gain is applied in the
signal path just before the fader.
Panorama Position
Lets you preset pan settings for this input. Pan is
variable in 49 steps, center being 0, far left -24 and far
right +24. This setting can be adjusted on the fly by the
operator if permitted by show profile settings.
Equalizer
If the check box is selected, the EQ function is en-
abled for this source profile. The EQ function provides
three band EQ with sdjustment of the frequency of each
band and the gain of the band. The QOR has a limit of 8
simultaneous channels with EQ.
Figure 2-4: Codec Source
