Axi STS 6030, Instruction, Operating, & Maintenance Manual

Page: 15 / 27

REV03026730010220
14
Controller
Setting the Current Date and Time (6000 Series Controller)
•
Please make sure the selector switch is set to “OFF” and push the Alarm Reset button on the enclosure door
panel.
•
When power is first applied to the system, the display of the PLC will show (blinking) the date and time.
•
Hit the “ESC” button.
•
Select ‘Stop’ and press “OK”.
•
Select ‘Yes’ (use down arrow key) and press “OK”.
•
Select ‘Setup’ (use down arrow key) and press “OK”.
•
Select ‘Clock’ and press “OK”.
•
Select ‘Set Clock’ and press “OK” ( must be in military format ).
•
Using the arrow keys, set the current day of the week, time and date as indicated in the display and press “OK”.
Use the up and down arrow keys to change values, and use the left and right arrow keys to change between
week, day, time, and date.
•
When finished entering press “OK” to confirm.
•
Press “ESC” until the base menu is displayed.
•
Select ‘Start’ and press “OK” – correct time and date should be displayed (when prompted, select “YES” to
proceed).
Programming the Timer (6000 Series Controller)
1. Hit the “ESC” button from the time and date display. If they are not shown, hit the down arrow button until they are
displayed.
2. Select ‘Program’ and press “OK”.
3. Select ‘Set Param’ (use arrow keys) and press “OK”.
4. Use the arrow key to select the ‘Timer’ and Press “OK”.
5. Use the arrow keys to select the desired field and press “OK” to edit.
6. Use the left and right arrow keys to select the day/days of the week the system should automatically turn on, and
the up or down arrow key to activate the selected day.
7. Use the arrow keys in same manner to program the ‘On’ time for when the system will switch on (on the selected
day/days).
8. Use the arrow keys in same manner to program the ‘Off’ time – when the system will switch off.
9. Press “OK” to confirm the entry when finished setting all desired parameters.
10. If required, you can set up to 3 Timers by using the up and down arrow keys.
11. Press “ESC” until the time and date screen is displayed.
Setting the Current Date and Time (7000 Series Controller)
1. Please make sure the pump is set to “OFF”.
2. On the home screen, long-press (for a few seconds) to the right of the AXI logo until a new screen appears.
3. Select ‘Enter Info Mode’.
4. Once prompted, enter ‘1111’ for the password.
5. Select ‘Time and Date’.
6. Select and set the current time and date in military format.
7. Once finished, continually press ‘ESC’ until you are returned to the home screen. The updated information should
be shown in the header of the touch screen pages.
Programming the Timer (7000 Series Controller)
1. From the home screen, select ‘Timers’.
2. Once on the ‘Timers’ screen, you can set up to 3 run timers for each day of the week.