V-Series Dobby Loom User’s Manual
Loom Assembly
Installation Of The E-Lift II
Page | 47
Install The Cam-Cylinder-To-Slide-Plate Cable
1)
Immediately to the right of the larger Cam is the Cam-Cylinder.
Remove the wrap and unwind the Cam-to-Slide-Plate Cable. This
cable ends in a loop.
Figure 39 - Cam Cylinder
2)
Manually lift the slide plate that slips up and down on the slide rods,
mounted to the Dobby Back. If you lift it far enough, it will pass
over the little dobby balls. Several of them will act as support for
the slide plate.
3)
When the slide bar is up, a large hole located in the center of the
bottom plate of the Dobby Back can be seen. Slip the loop up
through the hole and drop it over the open tip of the large, opened
eye bolt on the underside of the slide plate.
