V-Series Dobby Loom User’s Manual
Loom Assembly
Install Beater
Page | 39
4)
Orient the support so that the support is placed on the loom as
shown. The spacer with the threaded rod and metal bracket should
face the front of the loom. The metal bracket will overlap the Lower
Horizontal.
Figure 33 - Beater Support
5)
The Rear spacer of the support has a bolt already installed. Remove
the lock nut and washer from it and insert the bolt through the right
Lower Horizontal.
6)
Slip the washer and nut back on and tighten the nut just to the
point where it almost cinches the two parts together. Leave it a
little bit loose so that the Beater Support can pivot during
adjustment.
7)
Locate two 1-1/2” long screws located in the beater hardware
package. Position the metal bracket at the front of the Beater
Support over the two pre-drilled holes in the Lower Horizontal (#1,
#11) and insert the screws. Tighten them down.
8)
Repeat these steps for the other side.
