Avidity Science Pico PICO10T2, Operation Manual

Page: 16 / 40

Pico Water Purification System Operation Manual Avidity Science, LLC
10
Installation and Setup
2. Connect one end of the bypass tubing ( A ) to the open end of the green RO water outlet tube ( B )
and the open end of the white reservoir inlet tube ( C ) as shown in Figure 6. Use the provided
elbow fittings.
Figure 6. Bypass tubing connected.
3. On the control display, press .
4. Press .
5. Press . The inlet valve will open and begin flushing the unit.
6. When asked if RO module is installed, touch
7. Allow the pressure to adjust and stabilize for approximately 3 minutes and then take one of these
actions.
8. Turn off the water to the Pico unit.
If the pressure is Then,...
Less than 0.5 bar Go to step 8.
Greater than 0.6 bar Press OK and got to step 13
A
B
C