TYPE F
TYPE N
STEP 20: INSTALL OUTER SEAL
Place the outer body seal on the spring, engaging
the spring tab into the hole in the boot.
STEP 21 (TYPE N ONLY): INSTALL
SPRING ADJUSTER
Turn the spring adjuster screw counter-clockwise
until the bottom is flush with the bottom of the
adjuster. Then install the spring adjuster on top of
the outer body seal, engaging the spring tab into
the hole in the spring adjuster.
STEP 22: PART & TOOL ORIENTATION
At this time, take a moment to arrange and orient
the flat washer, detent washer, and torque arm
fixing nut for installation. If they are ready to go,
they will be much easier to install while holding
the spring-loaded torque arm in place.
After the torque arm is on, the installation order
will be as stated above (flat washer, then detent
washer, then torque arm fixing nut.)
Of these pieces, the detent washer is the only
one with a “right-side up” and “up-side down.” If
you look at the profile, there is a sharp edge and
a rounded edge. The rounded edge goes up.
This allows the outboard adjustment knob to be
installed fairly easily as it is pressed on over the
rounded outer edge, while the sharp inner edge
keeps it firmly in place.
Sharp
Edge
Rounded
Edge
17