8
M3060 User Instructions
1
General information and warnings
1.2 Installation
1.2.1 Safe handling of equipment with batteries
1.3 Routine maintenance
Always turn off the machine and isolate from the power supply before starting any
routine maintenance to avoid the possibility of electric shock.
Make sure that it is placed securely on a flat and level surface.
DANGER: RISK OF ELECTRICAL SHOCK. NO USER SERVICEABLE
PARTS. REFER TO QUALIFIED SERVICE PERSONNEL FOR SERVICE.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer’s instructions.
ATTENTION: Il y a danger d'explosion s'il y a remplacement incorrect de la
batterie, remplacer uniquement avec une batterie du même type ou d'un type
équivalent recommandé par le constructeur. Mettre au rebut les batteries
usagées conformément aux instructions du fabricant.
IMPORTANT: This equipment must be routinely checked for proper operation
and calibration.
Application and usage will determine the frequency of calibration required for
safe operation.
CAUTION: Do not weld on or near the M3060 or any part of the scale system
such as Weigh Bars. Excessive heat and / or high currents may cause internal
damage. Physically remove the M3060 from any equipment it is mounted to and
disconnect it from the power source. Make ground connection as far away from
any scale part (cables, Weigh Bar, etc.) as possible.
