Avery Dennison SS Finisher, User Manual

Page: 32 / 72

Users Manual SS Finisher Trouble Shooting

32
Troubleshooting Electrical
Power Up / Sign On Communications
Problem Probable Cause Remedy
A - Machine fails to power
up
1
– Incorrect power amplitude
1 - Confirm that the AC entry is configured for
the line voltage intended to be applied to
the machine. Failure to do so can damage
the machine’s internal power supply. Refer
to the “Fuse Configuration”
2
– Lack of power to the
machine
2 - Check that both ends of the power cord are
securely plugged in.
2A - Confirm that the outlet the machine is
plugged into has power.
3
– Missing or blown fuse(s)
3 - Check that the fuse(s) located inside the AC
entry are present and intact. Replace as
needed. Refer to the Fuse Configuration.
4
– Unconnected cable /
connector inside machine.
4 - Power off and remove the power cord from
the AC entry. Remove the back cover and
inspect the cables and connectors to and
from the power supply. Refer to the
“Electrical System Schematic”.
B - Front panel displays no
text or nothing at all
1
– Front panel cable
unplugged.
1 - Power off and remove the power cord from
the AC entry. Remove the back cover and
inspect the cables and connectors to and
from the front panel. Refer to the “Electrical
System Schematic”.
C - Front panel does not
complete diagnostic test
1.
1
– Front panel board
unplugged from the main
board.
1 - Power off and remove the power cord from
the AC entry. Remove the back cover and
check connectors.
D - Stock does not advance
when the start button is
pressed.
1
– An interlock condition exists. 1 - Determine the number and type of
interlock(s) by reading the front panel
display. As each is corrected, the number
of errors will decrease.
2
– Tag length or Offset values
are invalid.
2 - Check values located in front panel and
adjust.
3
– Feed motor unplugged or
faulty
3 - Check feed motor cable and/or replace feed
motor.
4
– Feed roller not gripping
stock
4 -
Adjust feed pressure. Refer to “Mechanical
Adjustment of Feed Roller Pressure”.
5
– Feed rollers bound
5 - With power off, check that all rollers turn
freely.
6
– Stock Bound
6 - Check that stock will pull through the printer
with little or no resistance.
E - The Stacker fails to run. 1- The stacker cable is not
connected
1 - Power off and remove the power cord from
the AC entry. Remove the back cover and
inspect the cables and connectors.
2
– Faulty Stacker Motor
2 - Replace Stacker Motor.
3
– Stacker jammed.
3 - Remove cause of the jam at the stacker.