Avery Dennison SS Finisher, User Manual

Page: 19 / 72

Users Manual SS Finisher Adjustments

19
Adjusting Knife Pressure
This new design comes with factory set knife pressure. The following
diagram shows the factory settings for pressure with a new top blade.
Should the unit stop cutting, the knife blade should be leveled first, and if
unsuccessful, add pressure with the “Adjusting Knife Spring Pressure”
instructions above.
A means to adjust this pressure is built into the knife linkage. To make
this adjustment, first the .015” gap must be set - followed by the .750”
gap.
To set
the .015” gap, jog the machine until the knife blade is in its full
down position with no fabric under the blade. Loosen the LOCK KNOB
and turn the ADJUSTMENT NUT until the gap is at .015”. Retighten the
LOCK KNOB.
To set the .750” gap, jog the machine until the knife blade is in its full
down position with no fabric under the blade. Loosen the screw on the
ADJUSTING NUT; turn the ADJUSTMENT NUT until the gap is .750”.
Tighten the setscrew.
.750
.015
POSITION
START & OPERATION
Proximity Switch Adjustment
The Proximity Switch triggers the Ultrasonic Power Supply to begin
generating Ultrasonic energy during the cut. If the Proximity switch is not
adjusted properly, the Power Supply will not be triggered and the unit will
not cut.
The Proximity Sensor Flag (see illustrations below) should be adjusted as
shown. The flag should be positioned so that there is a 0.015” (0.4mm)
gap between the Flag and the face of the Switch. When the C-Sensor
flag is in the six o’clock positions, the proximity flag should be
approximately 90 degrees above the proximity sensor.