Avery Dennison SS Finisher, User Manual

Page: 28 / 72

Users Manual SS Finisher Trouble Shooting

28
blank area of the label in the feed direction. This should be done
manually.
Cut Position
When the desired feed length has been selected, start the printer and run
labels into the stacker. After two or three labels have fallen into the
stacker - stop the printer and remove the top label. Measure the distance
from the end of the label to the desired cut location. Add or subtract the
value from the value displayed. DO NOT input the value, it must be
added to or subtracted from the current value. The maximum value is ±
the label length from zero. The cut value cannot be greater than the label
length. The cut number for the label illustrated below should be
decreased by 19mm to cut in the center of the registration mark.
COPY AREA
FEED
10 20 30 40 50 60 70 80
Use the arrow keys to

increase or

decrease the displayed value.
The value will change in single millimeter increment by holding the button
or single button pulses. The value that is displayed will be the new
length, no save key is required.