12/14 Rev. 03
USER MANUAL
Commissioning & Operation
64-xx
2
Mounting the Printer
Unpacking the 64-xx
1. Lift off the lid of the shipping box [1].
2. Take out the plastic bag containing the
accessories [1B].
3. Lift off the styrofoam support [1A].
4. Part the plastic cover [2].
[4]
D o n ´t use the cutter as a handle!
5. Grab the printer from underneath and lift it
out. The material feed slot in the back wall
of the printer [3A] can be used as a
handle.
Printers with mounted cutter: The motor
[4B], but
not
the cutter [4A] may be used as
a handle!
6. Place the printer on a level surface in its
usual operating position (rubber feet [4C]
at the bottom).
The
original packaging
should always be
used for transporting the printer!
WARNING!
Printers with mounted cutter: The
cutter may cause cut injuries.
Do not grasp the cutter [4A] as a
handle.
Use the cutter motor [4B] as a
handle.
CAUTION! - Do not lift the printer by
the front cover [4B]. The front cover is
a movable part not designed for
handling stress.
[1]
Shipping box without lid:
A
Styrofoam support
B
Accessories
[2]
Open the plastic bag...
[3]
Lift the printer out of the box.
A
Back wall of printer (not visible)
B
Front cover (do not use for lifting)
C
Rubber feet
A
B
B
C
A
A
B
