03/13 Rev. 5.08-01
USER MANUAL
Einrichten
64-xx – 64-xx dispenser
9
Changing material
Proceed as described in the following to
replace an inserted material roll befor it
comes to an end.
The printer must be switched on;
otherwise, the printhead presses on the
material.
64-xx
1. Switch the printer to offline mode and open
the front hood.
2. To remove the material, press the opener
while at the same time pulling the material
away to the rear (Fig. 2).
64-xx dispenser
1. Switch the printer to offline mode and open
the front hood.
2. Tear the backing paper off (2), pull out the
clip (Fig. 3) and remove the wound up
backing paper (Fig. 4).
3. Open the shutter (3) and pull out the
remaining backing paper towards the dis-
pensing edge.
4. To remove the material, press the opener
while at the same time pulling the material
away to the rear (Fig. 2).
It is also possible to convey the material
backwards out of the print module by
pressing the Cut keys in offline
mode.
1
2
3
