03/13 Rev. 5.08-01
USER MANUAL
Einrichten
64-xx – 64-xx dispenser
17
Settings at 64-xx dispensers
Dispenser types
The 64-xx is available as „Dispenser M“ or „Dispenser A“ (see tab. 2).
Basic settings
The following table shows a basic setting for those parameters which are
most important for dispenser operation (see tab. 3). The setting can be
applied to both, type M and type A, with the purpose of using a
footswitch
.
It is
not
possible to connect two foot switches to the printer (USI and
Single Start) and use them simultaneously.
Advice on setting parameters can be found in topic section
Info printouts
and parameters
.
Type
Property
Operating mode
64-xx Dispenser M
•
Short dispensing edge with
label sensor
•
Connector for start/stop
signal (e. g. for footswitch)
Printing/dispensing is triggered manually
(single start), e. g. by a footswitch. The
dispensed labels are taken off by hand.
Alternatively:
Printing/dispensing is trigge-
red by the label sensor, if a dispensed
label is taken off.
64-xx Dispenser A
•
Long dispensing edge
without label sensor
•
Connector for start/stop
signal (e. g. for footswitch)
Printing/dispensing is triggered manually
(single start), e. g. by a footswitch. The
dispensed labels are taken off by hand.
Alternatively:
The dispensed label is taken
over by an applicator.
[Tab. 2]
Different configuration of „Dispenser M“ and „Dispenser A“.
Submenu
Parameter
Setting
SYSTEM PARAMETERS
Periph. device
Dispenser
External signal
Singlestart
Start print mode
Pulse rising
DISPENSER PARA
Dispense Mode
Real 1:1 Mode
Dispensposition
0 mm
Dispensing mode
fast
Application mode
Immediate Mode
Start source
Foot switch
Dispensing edge
short
Transport mode
Dispenser motor
[Tab. 3]
Basic setting of the parameters most important for dispenser operation - valid
for both dispenser versions.
