03/13 Rev. 5.08-01
USER MANUAL
Einrichten
64-xx – 64-xx dispenser
11
Material / Ribbon end
Material end
If the material end has passed the material guiding, the following status
message appears:
1. Press the opener and pull the remaining material from the front side
(display side) out of the print unit.
2. Only dispenser version:
Open the shutter and pull the remaining backing paper in direction
rewinder out of the print unit.
3. Take the clip off the rewinder and remove the wound up backing paper.
For additional information read section
Changing material
on page 9.
Ribbon end
If the ribbon roll is emptied, that is the ribbon unwinding mandrel stopped
turning, the following status message appaers:
Proceed as described in section
Inserting ribbon
on page 10.
The ribbon end detection can be switched off, e.g. for thermal printing.
To do so, set the parameter
SYSTEM PARAMETERS > Ribbon autoecon.
to „ther-
mal printing“.
Rewinder full
Only for dispenser versions!
The dispenser rewinder can wind up the backing paper of a roll with
210 mm outer diameter and 4“ (102 mm) core inner diameter. If the ma-
ximum capacity of the rewinder is reached, the following status message
appears:
Proceed as described in section
Changing material
on page 9.
Best clear the rewinder after every printed material roll!
Status 5002
Material end
Status 5008
Ribbon end
Status 5064
Rewinder full
