MIB-II
Issue 1 August 2006
107
ifSpeed (5)
An estimate of the interface's current bandwidth in bits per second. For interfaces which do not
vary in bandwidth or for those where no accurate estimation can be made, this object should
contain the nominal bandwidth.
ifPhysAddress (6)
The interface's address at the protocol layer immediately "below" IP in the protocol stack. For
interfaces which do not have such an address (e.g., a serial line), this object should contain an
octet string of zero length.
ifAdminStatus (7)
The desired state of the interface. The testing(3) state indicates that no operational packets can
be passed.
ifOperStatus (8)
The current operational state of the interface.
up(1)-- ready to pass packets
down(2)
testing(3)-- in some test mode
The testing(3) state indicates that no operational packets can be passed.
ifLastChange (9)
The value of sysUpTime at the time the interface entered its current operational state. If the
current state was entered prior to the last re-initialisation of the local network management
subsystem, then this object contains a zero value.
ifInOctets (10)
The total number of octets received on the interface, including framing characters.
ifInUcastPkts (11)
The number of (subnet) unicast packets delivered to a higher-layer protocol.
ifInNUcastPkts(12)
The number of non-unicast (i.e., subnet broadcast or subnet multicast) packets delivered to a
higher-layer protocol.
ifInDiscards (13)
The number of inbound packets which were chosen to be discarded even though no errors had
been detected to prevent their being deliverable to a higher-layer protocol. One possible reason
for discarding such a packet could be to free up buffer space.
ifInErrors (14)
The number of inbound packets that contained errors preventing them from being deliverable to
a higher-layer protocol.
ifInUnknownProtos (15)
The number of packets received via the interface which were discarded because of an unknown
or unsupported protocol.
ifOutOctets (16)
The total number of octets transmitted out of the interface, including framing characters.
Summary of Contents for Communication Manager IP DECT
