Stop
A stop removes the component from service immediately, regardless of whether the
component is currently processing calls. All active calls are dropped. Typically, you perform a
stop only when severe problems that affect a large number of incoming calls occur or if your
organization determines a special need for it.
Components that can be started and stopped
You can start and stop only the following components.
Note:
If you want to start or stop more than one or two multimedia (DSP) or call (DS30X) channels,
use the Multimedia Monitor or Channel Monitor. For instructions, see
with the Multimedia and Channel Monitors
on page 63.
Component
Effect of stopping
Motherboard (IPE server)
Removes all call processing resources on the selected
board from service.
Time Switch
You cannot perform maintenance administration on
the time switch.
Multimedia channels
Removes the selected DSP from service.
Channels
Removes the selected DS30X channel from service.
DS30X link
Removes the selected DS30X link from service.
To start or stop a component
1. Run CallPilot Manager and log on.
2. In CallPilot Manager, click Maintenance, Maintenance Admin.
The Maintenance page appears.
3. Click the plus sign (+) beside the CallPilot server to expand the component tree.
4. Continue clicking the plus sign (+) until the component with which you want to work is
visible.
5. Click the hardware component that you want to start or stop.
The Maintenance page refreshes to show details about the component.
Using CallPilot Manager to monitor hardware
56 Avaya CallPilot 202i Server Maintenance and Diagnostics
December 2010