23
20. ANSWERING MACHINE BYPASS
In case the alarm panel connected with fax or answering machine on the same telephone line (not
recommended) enable the Answering Machine Bypass or Answer Now features (otherwise
connection is impossible).
To enable the feature:
1. Program 7 at address 074
2. Program at least 24 seconds at address 096 (Ring Time Out)
Now dial to the control panel, count at least three rings and disconnect, dial again after 10 seconds
–
the panel will answer at first ring.
When Answering Machine Bypass enabled, the control panel will answer at first ring if:
- There was a pause of at least 10 seconds from last ring
- The panel already counted at least three rings before the pause
- Number of rings to answer (at address 091) is less than 20
Notice: The panel will answer (in a normal mode) if there is no pause and the rings counted
exceed (or equal) the number programmed at 091.
21. TELEPHONE LINE TEST
Software Telephone Line Monitor (test), address 094: Time interval between telephone line tests -
in hours.
Range between 00-24.
When ‘
00
’
programmed no test performed. Failure to get a dial tone when
dialing will cause a "Phone Line Fault" event.
22. ID CODES FOR COMMUNICATOR - EASY PROGRAMMING
Refer to programming table, part 10; System is in program mode, enter ID address, 4 LEDs are
blinking, enter the subscriber ID code in sequence.
Example: Your subscriber ID number is 2170 for Closing/Opening of telephone 1; refer to address
number 376. Keypad in programming mode, ‘P’ is displayed, press 376, 4 LEDs are blinking,
enter 2170.
Note: Even if your communicator receiver requires three digits for the subscriber ID, enter
four digits. The system will ignore the fourth digit automatically
If your central station that requires programming of letters as well as numbers, please refer to the
HEX programming description. Use the regular programming method of entering each letter or
number in each address, as explained in the programming table (HEX method).
Note: EASY Programming is not included in the EasyLoad screen (programming via
computer).
