16
4. The two left-most LEDs blink to indicate that the system is waiting for a new user code-index
(user 1 to 8) to be entered.
5. Enter the code index you want to be delete (1 for code No. 1; 2 for code No. 2, etc.)
6. The two right-most LEDs blink to indicate that the system is waiting for a new code.
If user code is not entered, the code is voided; short sounder beep confirms code has been
deleted.
7. It's possible to enter a new code; ‘U’ is displayed for confirm
ation.
8. To quit code setting hold-
down key ‘9’.
Auto Arming (version 2.09 and upper)
Programming the time for Automatic Arming:
- By Installer: Program (or display) hours and minutes at address 016.
- By User: Enter to user programming mode. Hold down '8' ('A' is displayed); type hour and
minutes in 24 hours format. To display, hold down '8' and wait. To disable Automatic Arming
program 0000.
After Automatic Arming is programmed, the system time can be set only via User Programming
Mode: Enter User Programming Mode (hold-down 8 and 1234), hold down '1' ('t' is displayed) and
type hour and minutes. Hold down '1' and wait for the time to be displayed. Holding down keys
'0'+'1' to program the time is possible only if the Automatic Arming is disabled (otherwise an
'Error’ warning is displayed).
16. CROSS ZONE FEATURE (AV-2004 only)
This feature removed starting version 3, not available with “d” panels.
