Autronica AutroVoice miniVES 2001, Service Manual

Page: 95 / 156

95
6
Audio Outputs / Name
The AutroVoice miniVES has 3 independent audio outputs. Double-clicking the name of the audio output enables to change
the generic name assigned by the configurator.
7
Audio Outputs / Connection
This tab displays the internal connection of a given audio output. Unlike the AutroVoice MULTIVES system these connections
are predefined in the AutroVoice miniVES. The first one being wired to the internal speaker, the second one is connected
to the internal 100 V bus through the amplifier modules providing 100 V signal to the line control cards and the third one is
a line output located on the AutroVoice miniVES charger module. The line output is not monitored by the system. The unit
treats the output line as a zone in the system (eg. signal to an independent PA system) to which it can transmit the message.
8
Audio Outputs / Pilot active
Selected Active Pilot option activates the control of the connection between audio output (DSP) and amplifier module.
The pilot signal is also used by the line control cards to supervise the speaker lines.
9
Audio Outputs / Feedback Destroyer
Activating Feedback Destroyer means that in places where the speakers are located in close proximity to the system
microphone, the effect of acoustic feedback will be significantly limited.
q
Audio Outputs / Signal Processing
The window allows to change parameters like delay, volume level, limiter threshold and EQ. Setting the parameters
is possible in two ways:
1. by changing the values in a particular window Volume / Delay and uploading the configuration to the system;
2. by changing the parameters in the Volume / Delay section in on-line mode.
Outputs 2 and 3 of the AutroVoice miniVES Central Unit have an 8 band parametric equalizer which can be freely
configurable in two ways:
1. by changing the center frequency, filter quality and gain and uploading the configuration to the system;
2. by changing the parameters of the filters in on-line mode.